Thread: Microscope
View Single Post
  #3  
Old 04-30-2017, 10:04 PM
airamp airamp is offline
Platinum
 
Join Date: Mar 2008
Location: Scottsdale, Az.
Posts: 684
Default Re: Microscope

Hi,
Why don't you try doing a very light cut first then go over it deeper.
Also you can not use the scope for awhile and just practice cuts.
there are a couple of good practice plate prints on the site.
You can also tilt the vise slightly to get a slightly different site picture.
Also run your thumb on the plate when cutting until you get the right angle you like. It will act as a pivot for angle of cut.
AirAmp
Reply With Quote