View Single Post
  #4  
Old 10-25-2011, 06:23 AM
DKinYORKpa DKinYORKpa is offline
Copper
 
Join Date: Oct 2011
Location: PA
Posts: 4
Default Re: Is this antique for engraving?

Quote:
Do you have all machine's parts?
Hard to say, of course! The tool appears to fit into the square hole on the block of metal that's attached to the moving business end above the wooden circle. There's a set-screw hole there. Examining the whole thing, there's no obvious shadows or unexplained holes from a missing part, though. At lunch, I'll insert the pic that shows this.
Reply With Quote