Engraving Forum.com - The Internet's Largest and Fastest Growing Engraving Community

The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,732. Welcome to our newest member, Miss Allison
EngravingForum.com - Domain since Feb 7, 2003

Graver Video Conferencing is empty Join now!


Go Back   Engraving Forum.com - The Internet's Largest and Fastest Growing Engraving Community > Forums > Lindsay AirGraver Info - Hand Engraving Forum
ENGRAVING TOOLS - Paypal accepted Classes Glossary Feedback Tips Sharpening Bulino Videos Forum Policies

Reply
 
Thread Tools
  #1  
Old 10-30-2016, 12:12 PM
Steve Lindsay's Avatar
Steve Lindsay Steve Lindsay is offline
Administrator
 
Join Date: Feb 2006
Location: Kearney, NE
Posts: 4,552
Default PalmControl Vise - Jaws info

I'm not sure if those with a PalmControl vise and the multi-coin holder know it, but the jaws of the coin holder will fit right on the jaws of the PC vise. Remove the bolts holding the pin-plates on the pc vise to remove them, and use the screws that came with the multi-coin holder to attach the coin jaws to the top of the PC vise jaws.

__________________
__________________________________
Steve Lindsay
AirGraver.com
EngravingArtist.com
Reply With Quote
  #2  
Old 10-31-2016, 06:30 PM
roy6g@aol.com roy6g@aol.com is offline
Copper
 
Join Date: Oct 2016
Location: charleston wv
Posts: 1
Default Re: PalmControl Vise - Jaws info

I was wondering if the large vices would adapt to the coin holder
Reply With Quote
  #3  
Old 10-31-2016, 07:44 PM
Steve Lindsay's Avatar
Steve Lindsay Steve Lindsay is offline
Administrator
 
Join Date: Feb 2006
Location: Kearney, NE
Posts: 4,552
Default Re: PalmControl Vise - Jaws info

Hi, The multi-coin holder base has a block under it so that it can be clamped in any vise.
The coin jaws won't screw directly to the top of the Titan vise since the spacing of the bolt holes are different. An adapter plate could be made to do it though. It would have a set of holes for the vise jaws and a set of holes for the coin jaws.

Here is a photo of the coin holder on the top of the pin-plates of the Titan. The pin-plates could be removed and then clamped in the main jaws too though.

__________________
__________________________________
Steve Lindsay
AirGraver.com
EngravingArtist.com
Reply With Quote
Reply

Bookmarks

Thread Tools

Posting Conduct
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -6. The time now is 04:54 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.