|
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,762. Welcome to our newest member, Katherine
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
|||||||
| ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
 |
|
|
Thread Tools |
|
#1
03-23-2017, 07:26 PM
|
|||
|
|||
co2 vs compressed air
I'm sure that this has been asked a 100 times but I can't find anything on this. Well sorry about that folks after looking a little harder I see there are plenty of posts and good info on my question! Found all I was looking for
|
|
#3
03-24-2017, 03:14 PM
|
||||
|
||||
|
Re: co2 vs compressed air
Hi Jack, Either Co2 or compressed air works. Here is a thread about cfm usage
http://www.engravingforum.com/showth...5147#post15147 Co2 is great for being portable but If you are working at a permanent location it is hard to beat an air compressor since it does not require refilling.
__________________
__________________________________ Steve Lindsay AirGraver.com EngravingArtist.com
|
|
| Bookmarks |
|
|
